Fast!UTIL
Selectable Boot Settings
This option enables you to select the node name from which you want to boot. Once enabled, this option forces the system to boot on the selected FC hard disk, ignoring any IDE hard disks attached to your system. If you disable this option, the system looks for a boot device (as selected in the system BIOS). In disabled mode, the Boot ID and Boot LUN parameters have no effect.
Some new system BIOS support selectable boot, which supersedes the Fast!UTIL selectable boot setting. To boot from an FC hard disk attached to the HBA, select the HBA Fibre Channel hard disk on the system BIOS.
Note: This option applies only to hard disks; it does not apply to tape drives and other nondisk devices.
Restore Default Settings
This option restores the HBA default settings.
Raw NVRAM Data
This option displays the adapter’s NVRAM contents in hexadecimal format. This is a troubleshooting tool; you cannot modify the data.
Advanced Adapter Settings
From the Configuration Settings menu in Fast!UTIL, select Advanced Adapter Settings. Table 7 lists the default settings for the HBA:
Table 7: Advanced Adapter Settings
Setting | Options | Default |
Execution Throttle | 16 | |
|
|
|
Fast Command Posting | Enabled, Disabled | Disabled |
|
|
|
4GByte Addressing | Enabled, Disabled | Disabled |
|
|
|
Luns per Target | 0, 8, 16, 32, 64, 128, 256 | 128 |
|
|
|
Enable LIP Reset | Yes, No | No |
|
|
|
Enable LIP Full Login | Yes, No | Yes |
|
|
|
Enable Target Reset | Yes, No | Yes |
|
|
|
FCA2214/FCA2214DC | 45 |
Guide |
|
