Configuring HyperFabric

Configuring HyperFabric with ServiceGuard

available, ServiceGuard has not been notified; HyperFabric handles the local HyperFabric adapter failover. However, the failure of adapter 1 has been logged to /var/adm/clic_log.

Figure 4-4 Node with One Failed HyperFabric Adapter

 

node A

 

 

HyperFabric

 

Resource Active

Package

 

 

A

Failed

HF

 

 

Adapter

adapter 1

Package

Active

HF

adapter 0

B

Adapter

 

Adapter IP addresses: 172.16.10.11 172.16.20.21

After the failover, if you issue a netstat -in command, you will see that an IP address is still assigned to each adapter. For example:

Name MTU network Address Ipkts Opkts clic1 31744 172.16.10.0 172.16.10.11 711 12 clic0 31744 172.16.20.0 172.16.20.21 1222 333

Example 3:

This final example, illustrated by Figure 4-5 below, shows a situation in which all of the HyperFabric adapters on node A fail. The HyperFabric Resource Monitor reports to the Event Monitoring Service (EMS). The EMS then notifies the ServiceGuard cmcld daemon that the HyperFabric resource on node A is unavailable. Because HyperFabric is configured as a package dependency for Packages A and B, ServiceGuard causes the packages to failover to node B. In a four-node configuration (note that only two nodes are shown in Figure 4-5 below), Packages A and B can continue to communicate through the HyperFabric network with the other active nodes in the ServiceGuard cluster.

Chapter 4

79

Page 79
Image 79
HP manual Node with One Failed HyperFabric Adapter