HP manual Configuring ServiceGuard with HyperFabric Using SMH

Configuring HyperFabric

Configuring HyperFabric with ServiceGuard

RESOURCE_UP_VALUE =UP

Configuring ServiceGuard with HyperFabric Using SMH

You must perform the following steps when using SMH to configure the HyperFabric Resource Monitor with ServiceGuard:

smh Clusters

High Availability Clusters

Cluster Configuration (go through all the steps to create a cluster)

Package Configuration

Create/Add Package (if creating new packages)

Specify Package Name and Nodes

Specify Package SUBNET Address

Specify Package Services

Specify Package Failover Options

Specify Package Control Script Location

Specify Package Control Script Information

Specify Package Resources Dependencies Add

Resource Name

(Navigate the Resource Subclass by double-clicking on /net until /net/interfaces/clic/ status shows up in the selection box Resource Name,then select it and click OK.)

Resource Parameters

-Input the Resource Polling Interval (for example, 10 seconds).

-Select “UP” from the “Available Resource Values” and click “Add”.

-Click OK to accept the values.

Configuring ServiceGuard for HyperFabric Relocatable IP Addresses

If you want to use relocatable IP addresses, configure the relocatable IP addresses with the IP[n] command in the package control script.

For example, to configure the relocatable address 192.0.0.3 for adapter 0 and 192.0.8.5 for adapter 1, specify this:

IP[0]= 192.0.0.3

IP[1]= 192.0.8.5

Chapter 4 81