Installing a CableCARD Module

You must obtain the CableCARD module from your local cable provider. After installing the card, follow any setup instructions provided with the card.

The following figure shows a typical CableCARD module, and is for illustration only.

1.Turn off the television. The CableCARD slot can be found in the back of the television.

2.Gently push the card into the slot until it stops. When fully inserted, the card will stick out slightly. Do not attempt to force the card into the television!

3.Press Menu. Press the left or right arrow buttons to go to Source > Cable card, and press OK. Your cable provider uses the information in the CableCARD screens to activate and configure the CableCARD service.

4. To remove the CableCARD module, first turn off the television, and then pull the card out of the slot. The CableCARD functions are then removed automatically.

Turning the Television On and Off

Plugging in the Power Cord

Plug the power cord into a polarized outlet.

CAUTION: Do not defeat the safety purpose of the polarized plug attached to the television. A polarized plug has two blades with one wider than the other. The wide blade is provided for your safety. If the polarized plug does not fit into your existing outlet, contact a qualified electrician to replace the obsolete outlet with a polarized outlet.

Setting Up the Television

19

Downloaded from www.Manualslib.com manuals search engine

Page 39
Image 39
HP ID5226N, ID5286N manual Turning the Television On and Off, Installing a CableCARD Module, Plugging in the Power Cord