•General assembly equipment locations
Lifting requirements
WARNING: The only approved method for lifting any section of the HP POD 240e NA is the use of a spreader bar or harness. Lifting any section of the HP POD 240e NA in any other way can cause damage to the HP POD 240e NA and void your warranty. The harness and lifting connections must be perpendicular to the lifting blocks or connections.
Storage requirements
If the site is not ready for assembly and operation, determine a location for storage when creating the site plan.
CAUTION: The HP POD 240e NA must maintain 20% relative humidity to minimize condensation and oxidation within the HP POD 240e NA.
CAUTION: While being stored, the HP POD 240e NA must be kept in a level position even if stored on a trailer.
Changes in ambient temperatures can cause condensation in a
•Desiccant unit
•Desiccant material
•Heater with a fan
•Air conditioner with a heater strip
Consult with HP Services to determine the most effective method.
Other structures
If you provide a vestibule or other structure that will be installed at the HP POD 240e NA site, you must maintain the following specifications:
•Flashing must be installed on the exterior of the HP POD 240e NA in the location where the other structure will be attached to protect the HP POD 240e NA and be sure that there is a waterproof barrier.
•Access catwalks and landings might be required to maintain the required egress from the HP POD 240e NA HVAC service area.
•Access catwalks and landings might be required to maintain the required access to the HP POD 240e NA electrical panels.
Site plan requirements and actions 24
