SECTION 2

INSTALLATION & SETUP

Setting up the Feed System

The printer is equipped with four sheet separators, two media side guides, a rear media guide, and a media thickness adjustment knob.

Sheet Separation Adjustment

The sheet separators are adjusted individually as follows:

1.Move the side guides so that the separator locking knobs are accessible.

2.Loosen each Separator Locking Knob, as shown in Figure 14, and raise each separator, then tighten the locking knob to hold the separator in the up position.

3.Place a single piece of media under the separators. It is best to place the media so it is center on the table.

4.Loosen the Separator Locking Knob. Let the separator fall onto the media and tighten the locking knob as shown in Figure 15. Repeat for each separator that has media under it.

IMPORTANT! Be sure that unused separators are locked in their raised position. If not, they will rub on the feed rollers, causing transport problems and or damage to the rollers and separators.

Figure 14

Figure 15

Media Side Guide Adjustment

1.Adjust the Media Side Guides so that they are about a dimes width (~1/32-inch) from the sides of the media. Tighten the locking screws on the side guides to secure their positions.

Figure 16

Envelope Imager 1.5/1.5+ Operations Rev. 6/7/2007

15