SECTION 2

INSTALLATION & SETUP

Paper Feed (Media Transport) Test

Test for proper media transport.

If the printer is setup properly, it should feed the media without hesitation, skewing or jamming.

1.With the printer off-line, press the ENTER key, to start the Paper Feed feature (feeds material without printing).

2.Press ENTER again to stop the Paper Feed feature.

TEST Print

When off-line, the TEST key can be used to print a TEST image.

The TEST image can be used to:

ƒCheck the vertical print position.

ƒDemonstrate the printer.

ƒCheck the condition or the ink cartridges.

ƒCheck the function of the printer.

Note: Horizontal print position is adjusted via your software (mailing program).

Customizing the TEST Print Image:

The TEST print image can be changed to any image you desire, by using the following procedure:

1.Power the printer on while holding down the TEST key.

2.From your computer; send an image that you would like to be the new TEST image.

Note: Turning the printer on, while holding down the TEST key, will erase the previous TEST image. If a new TEST image is not loaded, then a TEST image will not be available to print when you press the TEST key.

18

Envelope Imager 1.5/1.5 Plus Operations (Rev.6/7/2007)