Figure 17

SECTION 2

INSTALLATION & SETUP

Media Thickness Adjustment

Adjust the Printhead Carriage height, to accommodate the thickness of your media.

1.Turning the Media Thickness Knob [A] fully counter-clockwise, to raise the printhead carriage to its highest position.

2.Place a piece of media [B] under the printhead carriage rollers.

3.Adjust the Media Thickness Knob [A] clockwise until the printhead carriage rollers begin to touch the Media [B].

4. Continue to turn the Media Thickness

 

A

Knob [A] clockwise, an additional 4 or

B

5 clicks.

 

 

 

5.When properly adjusted the Media [B]

should be securely captured between the printhead carriage rollers and the

lower transport rollers. It should require some resistance to pull the Media [B] from under the printhead carriage rollers.

IMPORTANT! To help avoid ink wicking (ink leakage; caused when cartridge nozzles come in contact with an absorbent material) and to help avoid developing flat spots on the transport rollers; always raise the printhead carriage to the highest position, when the printer is not in use.

Loading Media

When placing media into the printer, it is important to follow these steps.

1.Start by placing a single piece into the feed section, so that it is touching or starting to feed under the sheet separators.

2.Fan the stack of material so the bottom pieces are closest to the separation point.

3.Additional pieces can be placed onto the stack, as described in the above step.

4.If the printer runs out of material, be sure to reload the printer beginning with the first step.

Figure 18

16

Envelope Imager 1.5/1.5 Plus Operations (Rev.6/7/2007)