SECTION 1
GETTING ACQUAINTED
Section 1 – Getting Acquainted
Safety PrecautionsTHIS EQUIPMENT PRESENTS NO PROBLEM WHEN USED PROPERLY. HOWEVER, CERTAIN SAFETY RULES SHOULD BE OBSERVED WHEN OPERATING THE PRINTER.
BEFORE USING THE PRINTER, YOU SHOULD READ THIS MANUAL CAREFULLY AND FOLLOW THE RECOMMENDED PROCEDURES, SAFETY WARNINGS, AND INSTRUCTIONS:
9Keep hands, hair, and clothing clear of rollers and other moving parts.
9Avoid touching moving parts or materials while the machine is in use. Before clearing a jam, be sure machine mechanisms come to a stop.
9Always turn off the machine before making adjustments, cleaning the machine, or performing any maintenance covered in this manual.
9Use the power cord supplied with the machine. Plug it into a properly grounded wall outlet located near the machine and easily accessible. Failure to properly ground the machine can result in sever personal injury and/or fire.
9The power cord and wall plug is the primary means of disconnecting the machine for the power supply.
9DO NOT use an adapter plug on the line cord or wall outlet.
9DO NOT remove the ground pin from the line cord.
9DO NOT route the power cord over sharp edges or trapped between furniture.
9Avoid using wall outlets that are controlled by wall switches, or shared with other equipment.
9Make sure there is no strain on the power cord caused by jamming between the equipment, walls or furniture.
9DO NOT remove covers. Covers enclose hazardous parts that should only be accessed by a qualified service representative. Report any damage of covers to your service representative.
9This machine requires periodic maintenance. Contact your authorized service representative for required service schedules.
9To prevent overheating, do not cover the vent openings.
9Use this equipment only for its intended purpose.
9Follow any specific occupational safety and health standards for your workplace or area.
This manual is intended solely for the use and information of Rena Systems Inc., its designated agents, customers, and their employees. The information in this guide was obtained from several different sources that are deemed reliable by all industry standards. To the best of our knowledge, that information is accurate in all respects. However, neither Rena Systems Inc. nor any of its agents or employees shall be responsible for any inaccuracies contained herein.
RENA Systems Inc. and “The Envelope Imaging Company” are a registered trademark of Rena Systems Inc.
Windows 98, 2000, NT and XP are registered trademarks of Microsoft Corporation. IBM is a registered trademark of International Business Machines.
All other trademarks are the property of their respective holders.
All rights reserved. No part of this manual may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying, recording, or any information storage and retrieval system, without permission in writing from Rena Systems Inc.
4 | Envelope Imager 1.5/1.5 Plus Operations (Rev.6/7/2007) |