Reboot options | Description |
| use this argument with the /reboot option, or the |
| argument is ignored. |
/reboot_delay timeout_in_secs | Delays the reboot of the server for the length of time that |
| the timeout_in_seconds variable specifies. You must |
| use this argument with the /reboot option, or the |
| argument is ignored. Acceptable values are between 15 |
| and 3600. |
| • The default timeout value is 15 seconds for Microsoft |
| Windows operating systems and 60 seconds for Linux. |
| • For Linux, the reboot delay time is converted from |
| seconds to minutes, and any value under a full minute |
| (59 seconds or less) rounds to the next minute. |
/reboot_always | If the following conditions are met, this argument forces |
| the server to reboot: |
| • The /reboot_always option is selected or given as |
| a |
| • All components selected for installation are successfully |
| installed. |
Simulating HP SUM | Description |
/dryrun | Simulates the installation for a test run. Nothing is installed. |
Targets | Description |
/user<username> or /username <username> | Use this argument to log in to the remote targets by using |
| the user ID. For the OA target, use the /oa_username |
| argument. |
/psswd <password> | Use this argument to use this password for the user ID |
| specified in the /user parameter (except for the OA |
| target). The password is used to log in to remote targets. |
| For the OA target, use the /oa_password argument. |
/target “netAddress” | This is the IP address or the DNS name of a remote host, |
| which can be a remote server, remote iLO NIC port, Virtual |
| Connect Ethernet or Fibre Channel Module for |
| BladeSystem, or BladeSystem OA. |
| When two OAs are in an enclosure, this argument should |
| be the active OA. When specifying the IP address, use |
| either the IPv4 or IPv6 format. |
/current_credential | Enables the credential of the local host to be used as the |
| credential to access the targets instead of providing the |
| user name and password explicitly for each target. The |
| assumption is that the current credential is valid for the |
| targets being accessed. (Applies to Windows only) |
/oa_username | This argument provides the user name credential for OA |
| associated with VC specified with the target |
| |
| can be specified with |
| add multiple VC targets to |
| the target parameter only if the credentials of OAs |
| associated with specified VCs are the same. The argument |
| oa_username is not required if VC has the same |
| credentials as the associated OA. You do not need to |
| provide an OA network address associated with VC. HP |
| SUM queries it from a specified VC target. |
