vClick Routing to open the Routing dialog.
vFor static routing, specify Add remote system as the default route. Since you
do not know the range of destination IP addresses, you need a default route.
This is the desired configuration when AS/400 dials in to an ISP such as IGN.
The default route forwards packets to the ISP router, which in turn routes the
packets throughout the Internet.
Click the Authentication tab.
vCheck ″Enable local system identification.″IGN requires customers to use the
Password Authentication Protocol (PAP)for authentication. This verifies the
identity of the customer who is using an unencrypted password.
vSpecify both a user ID and a password. In this example, the user name is
internet.account.userid. Other ISPs may use CHAP,which uses an encrypted
password. Consult your ISP to learn its requirements for specifying a user name
and password.
Click the Domain Name Server tab.
vSpecify the IP address for the Domain Name Server. In this example, the IP
address is 10.11.27.5. When you use an Internet Service Provider (ISP) to
connect to the Internet, you will receive a name server address from the ISP.
This allows you to connect using host names instead of IP addresses for remote
sites. Ahost name is a way of identifying a system and its IP address.
Example: Connecting two AS/400s using dial-on-demand
In this example, System 1 is a local system with IP address 10.11.25.1and System
2 is a remote system with IP address 10.11.25.2.To establish a connection:
1. Configure a Dial-only connection profile on System 1.
2. Configure a Switched line-answer connection profile on System 2.
3. Start connection profiles on System 1 and System 2 by using Operations
Navigator.
4. Verify configurations on System 1 and System 2 by using TELNET.

Configure a Dial-only connection profile on System 1

1. Access Point-to-Point functions through Operations Navigator.
2. From New Point-to-Point Profile Properties dialog, click the General tab and
do the following:
vType DODBP in the Name text box.
vType Basic Dial on Demand Profile in the Description text box.
vUnder Type, select PPP.
vUnder Mode, select Dial-on-demand (dial only).
3. Click the Connection tab and do the following:
vType the phone number of the remote system.
vUnder Line, select a line pool from the Name list.
vSelect Override line activity timeout and specify 300 seconds, or five
minutes, as the Timeout value.
4. Click the TCP/IP Settings tab and then do the following:
vUnder Local IP Address, click the radio button and type 10.11.25.1 in the
text box.
vUnder Remote IP Address, the Remote IP Address is 10.11.25.2.
98 OS/400 TCP/IPConfiguration and Reference V4R4