Working with RouteD Configuration
Use the
Work with RouteD Configuration
(WRKRTDCFG) command to change the
RouteD server configuration. The following are two different ways to get to this
command prompt:
vSpecify the
Work with RouteD Configuration
command, WRKRTDCFG.
vSelect option 2on the
Configure TCP/IP RouteD
(CFGTCPRTD) display.
Note: Youmust have *IOSYSCFG special authority to make changes to the
RouteD configuration with the WRKRTDCFG command.
RouteD Configuration Scenario
Figure 238on page 394 shows how the RouteD configuration entries work in a
sample network. The routers know every route within every network, including
networks X, Y,Z, A, and W.
Work with RouteD Configuration
System: SYSNAM01
Type options, press Enter.
1=Add 2=Change 3=Copy 4=Remove 5=Display 13=Insert
Sequence
Opt Number Entry
_____ 00010 #*************************** >
_____ 00020 # RTD DEFAULT CONFIGURATION >
_____ 00030 #*************************** >
_____ 00040 # >
_____ 00050 # RouteD Interface Definitions
_____ 00060 # ----------------------------
_____ 00070 # TCP/IP will learn about a route to network 9.0.0.0 th >
_____ 00080 # means external to RouteD, therefore do not allow Rout >
_____ 00090 # route to this network.
_____ 00100 #
_____ 00110 # RIP_INTERFACE * SUPPLY RIP1 METRIC 1 BLOCK 9.0.0.0 MA >
_____ 00120 #
_____ 00130 #
More...
F3=Exit F5=Refresh F6=Print List F12=Cancel F17=Top F18=Bottom
Figure 237. Work with RouteD Configuration
Chapter15. RouteD Server 393