server) was removed from the menu. Option 12, formerly Change local
domain and host names, was renamed to Change TCP/IP domain
information.
vOption 20. Configure TCP/IP applications: Select this option to configure the
TCP/IP applications that are installed on your system. The list of applications
varies depending on whether the TCP/IP licensed program is installed on your
system. If the TCP/IP licensed program is not installed on your system, you can
configure
only
the following server applications:
Simple Network Management Protocol (SNMP)
Bootstrap Protocol (BOOTP) server
Trivial File TransferProtocol (TFTP) server
Route Daemon (RouteD)
If the TCP/IP licensed program is installed on your system, you can configure the
following server applications:
Simple Mail Transfer Protocol (SMTP)
File Transfer Protocol (FTP), TELNET
Post Office Protocol (POP) Version3 mail server
Line Printer Daemon (LPD)
Remote Execution (REXEC) server
Workstation gateway applications
Simple Network Management Protocol (SNMP)
For information about configuring SNMP,see the

Simple Network Management

Protocol (SNMP) Support

book.
vOption 21. Configure related tables: Select this option to configure the tables
related to TCP/IP.These tables are:
Protocol table
Contains a list of protocols used in the Internet.
Services table
Contains a list of services and the specific port and protocol a service uses.
Network table
Contains a list of networks and the corresponding IP addresses for that
network.
vOption 22. Configure point-to-point TCP/IP: Select this option to define,
change, or display your TCP/IP point-to-point (SLIP) configuration.
Configuring TCP/IP using the Command Line Interface
The following steps using the command line interface will guide you through
configuring TCP/IP on your AS/400 system:
1. Configuring line descriptions
2. Configuring TCP/IP interfaces
3. Configuring TCP/IP routes
4. Configuring TCP/IP attributes
5. Configuring remote system information (X.25)
6. Configuring host table entries
Chapter2. Configuring TCP/IP 29