Power Requirements
The SureMark printers do not contain a power supply. When the printer is operating
in RS-232 mode, an external power supply must be attached to connector J2 of the
interface card of the printer. This connector is located under the printer and is
accessible without removing the printer covers. (See Figure 4on page 12 for
thermal/impact SureMark printers, and Figure 5on page 13 for single-station
SureMark printers.) Connector J2 has the following pin functions:
Pin Signal
1+24Vdc
2Not Connected
3Ground
When the SureMark printer is operating in RS-485 mode, power is supplied to the
printer from the IBM POS system. The system supplies 5V,24 V, or 38 V dc to the
printer.
When the SureMark printer has the USB feature installed and is using the powered
USB cable, 24V is supplied from the system unit.
When the SureMark printer has the USB feature installed and is using a 4-wire
cable with a Type B connector,you must use an external power brick (+24V dc).
Hardware Requirements
The SureMark printers work with the following systems:
vIBM 4694 systems (both SBCS and DBCS models)
v4614 (RS-232 connection only with power supply)
vIBM 4695 systems (RS-232 connection only and with power supply)
95 mm
(3.7 in.)
145 mm
(5.7 in.)
121 mm
(4.8 in.)
177 mm
(7.0 in.)
Figure3. SureMark Printer Dimensions Models TF7 and TM7
updated March 18, 2002
8SureMark DBCS Users Guide
|
|
|
|