Installing the FillersInstalling Fillers for RS-232/RS-485 Printers
Notes:
1. On an integrated unit, pull out on the locking lever at the left side of system unit.
2. Ensure that the side of each filler overlaps the tab on the side of the system
unit.
Toinstall fillers:
1. Power off the system and disconnect the RS-232 power supply (if connected).
See Figure 4 on page 12.
2. If you have a video display on an integrated system:
a. Move the display on its arm to the side and remove any tape holding the
alignment ring.
b. Remove the knockout section of the display filler.
c. Align the display filler with the alignment ring and slide the filler onto the
ring. Press the display filler into place. See Figure 12on page 20.
3. If you do not have a video display, place the display filler on the system unit. Do
not remove the knockout section. See Figure 12on page 20.
4. If you have a short keyboard, place the keyboard filler beside the keyboard. See
Figure 12 on page 20.
5. Place the printer filler beside the display filler. Make sure you route the printer
cable to the side, as shown in Figure 12on page 20.
updated March 18, 2002
Chapter2. Installation Instructions 19