2. Send all the data.
3. Release the buffer.
The left margin will be rounded down to a factor of 8. For example, if the
margin = 74, the logo starts at 72.
Retries are not attempted on print errors.
Valid at the beginning of the line only.
When printing in the document station, a line feed command must be sent
to advance the paper past the last line of the logo.
If the parameter d,w,orhis out of the defined range for this command, the
command is discarded and the remaining data is processed as print data.
This command will increment status byte 6.
If this message is printed on a regular basis, consider downloading it to
save communication time. (See “Download Graphics (Logo) Commands”on
page 109.)
The data buffer in the Model TI3 and Model TI4, which is 16 KB, can be
used for signature capture.
Print Predefined Graphics (Logo) Command
RS-232 Syntax:
GS / m logo_num or X'1D2F;m;logo_num'
where:
mThe dot-density:
00 Normal Print - 200 dpi in the receipt station, 150 dpi in the
document station.
Note: In the document station, this takes three passes of
the printhead for a logo that is 8 dots high.
01 Double wide - 100 dpi in the receipt station, 75 dpi in the
document station.
Note: In the document station, this takes one pass of the
printhead for a logo that is 8 dots high.
02 Double wide and high - 100 dpi in the receipt station, 75 dpi
in the document station. Every dot row in the vertical
direction will be printed twice.
logo_num
The number associated with the logo that is stored.
1≤logo_num ≤40
Purpose:
Toprint predefined all-points-addressable print messages.
updated March 18, 2002
AppendixC. RS-232 Programming Information 151