Infinite Peripherals 216 ESC $, GS P or GS $D0, ESC a n, Select justification, Justification

3. PRINTER FUNCTIONS

	by using the horizontal or vertical motion unit.
	Sets the distance from the current position to [(nL+ nH ⋅ 256)
	⋅ (horizontal or vertical motion unit)].				(Tab.A.3)
[Notes]	• Any setting that exceeds the printable area is ignored.
	• When the starting position is specified by n motion units to
	the right:
	nL + nH ⋅	256 = n
	When the starting position is specified by n motion units to
	the left (negative direction), use the complement of 65536:
	nL + nH ⋅	256 = 65536 – n
	• If setting exceeds the printing area width, the left or right
	margin is set to the default value.
	• The horizontal and vertical motion unit are specified by
	GS P or GS $D0.
	• GS P or GS $D0 can change the horizontal (and vertical)
	motion units. However, the value cannot be less than the mini-
	mum horizontal movement amount.
	• In standard mode, the horizontal motion unit is used.
[Default]
[Reference]	ESC $, GS P or GS $D0
[Example]
ESC a n
[Name]	Select justification
[Format]	ASCII	ESCa		n
	Hex	1B	61	n
	Decimal	27	97	n
[Range]	0 ≤ n ≤ 2, 48 ≤		n ≤ 50
[Description]	Aligns all data in one line to the specified position.
	n selects the type of justification as follows:
		n		Justification
		0, 48		Flush left
		1, 49		Centered
		2, 50		Flush right
[Notes]	• This command is only enabled when inserted at the begin-
	ning of a line.

• Lines are justified within the specified printing area.

• Spaces set by HT, ESC $ and ESC \ will be justified ac-

KPM210/216

3- 28 www.ipcprint.com