Infinite Peripherals 216, KPM-210 Hexadecimal Dump, Maintenance, Changing the paper roll

1. INSTALLATION AND USE

When the receive buffer is full, if handshaking is set to XON/XOFF, the printer sends the XOFF ($13) on the serial port.

When the receive buffer has cleared once again, if handshaking is set to XON/XOFF, the printer sends the XON ($11) on the serial port.

1.3 HEXADECIMAL DUMP

This function is used to display the characters received from the communications port; the printer prints out both the hexadecimal code received as well as the corresponding ASCII code.

Once the autotest routine has finished, the printer enters Hexadecimal Dump mode. The printer remains in standby until a key is pressed or characters are received from the communications port; for every 24 characters received (204 dpi version) or every 32 characters received (300 dpi version), it prints hexadecimal values and ASCII codes (if the characters appear underlined, it means the receive buffer is full).

Shown below is an example of a Hexadecimal Dump for the 204 dpi (24 character) version:

48 65 78 61 64 65 63 69 6D 61 6C 20 64 75 6D 70 20 66 75 6E 63 74 69 6F

6E 20 30 31 32 33 34 35 36 37 38 39 61 62 63 64 65 66 67 68 69 6A 6B 6C

6D 6E 6F 70 71 72 73 74 75 76 77 78 79 7A

Hexadecimal dump functio

n0123456789abcdefghijkl mnopqrstuvwxyz

1.4 MAINTENANCE

1.4.1 Changing the paper roll

To change the roll of paper, proceed as follows:

1)Position the paper roll (1) so that it unrolls correctly as shown in fig.1.2;

2)Insert the end of the paper roll in the paper load opening on the printing mechanism (2) and wait for the paper to load automatically (see fig. 1.2);

3)Remove the paper from the paper exit opening (3)(4).

(4)N.B.: The paper exit opening may be assembled in one of two positions, depending on the model in use (see fig. 1.2).

www.ipcprint.com 1- 3

KPM210/216