Infinite Peripherals 216, KPM-210

1. INSTALLATION AND USE

KPM210/216 21-

1.2 CONFIGURATION

This printer permits the configuration of default parameters. The printer’s

configurable parameters are:

•Interface (1): RS232D, USB (if present).

•Baud Rate (2): 57600, 38400, 19200D, 9600, 4800, 2400, 1200.

•Data length (2): 7, 8D bits/char.

•Parity (2): NoneD, even or odd.

•Handshaking (2): XON/XOFFD or Hardware.

•Receive buffer size (2): 16, 64, 1K, 4K, 8KD bytes.

•Autofeed: CR deactivatedD or CR activated.

•Print mode: NormalD or Reverse.

•Characters per inch:

204 dpi version: A=11 B=15 cpiD, A=15 B=20 cpi.

300 dpi version: A=17 B=23 cpiD, A=23 B=30 cpi.

•Speed/Consumption: Low, MediumD, High.

•Paper retract at power-up (3): DeactivatedD or Activated.

•Print density: -50%, -37%, -25%, -12%, NormalD, +12%, +25%,

+37%, +50%.

Please note: the parameters marked with the symbol D represent the default

values.

(1) N.B.:This parameter is displayed if the printer has an USB

interface.

(2) N.B.:If the printer has an USB interface, the serial interface

configuration parameters are not displayed.

(3) N.B.:If, at power-up, paper is present on the ejector and if this

parameter has been activated, the printer will retract the paper.

Otherwise, if the parameter is deactivated, the printer will eject

the paper.

The settings made are stored in EEPROM (nonvolatile memory).

During power-up, if the FORM FEED key is held down, the printer enters the

autotest routine and prints out the setup report. The printer will remain in

standby in Hexadecimal dump mode (see section 1.3) until another key is

pressed or characters are received through the printer communication port.

When the FORM FEED key is pressed, the printer enters parameter

configuration.

When the LINE FEED key is pressed, the printer exits setup and terminates

the Hexadecimal dump function.

(Tab.A.3)