Ingersoll-Rand 80445364 manual Unpacking, Dryer Installation

INSTALLATION / HANDLING 21

NOTES

1Foundation or floor must be level, and support all feet equally. If necessary, shim or grout the fourth foot.

2Foundation bolts should project thru nuts a minimum of 13mm [0.50”] to allow for levelling.

3Allow a minimum clearance of 1100mm [42”] on the front and 920mm [36”] on the top, left, right and the rear of the package for proper air circulation and serviceability.

4Approximate package weight: 475 KG. (1045 LBS)

NOTE

All dimensions are in millimetres (inches) unless otherwise stated.

Ensure that the correct fork lift truck slots or marked lifting points are used whenever the machine is lifted or transported.

UNPACKING

The compressor will normally be delivered with a polythene cover. If a knife has to be used to remove this cover ensure that the exterior paintwork of the compressor is not damaged.

Remove shipping bolts on end panel.

Ensure that all transport and packing materials are discarded in a manner prescribed by local codes.

DRYER INSTALLATION

Do not connect condensate drains common to other pressurised drain lines in a closed circuit. Make sure the outflow from the condensate drains is unimpeded. Connect the condensate piping in such a way to ensure that sound levels are kept to a minimum during drainage.

Ensure that all condensate is disposed of in a responsible manner, in accordance with local norms concerning environmental protection.

The ambient air around the dryer and compressor must not contain solid or gaseous contaminants. All compressed and condensed gases can generate acids or chemical products which may damage the compressor or components inside the dryer.

Take particular care with sulphur, ammonia, chlorine and installations in marine environments. For further advice or assistance consult your local Ingersoll Rand representative.

http://air.ingersollrand.com en