Remote control batteries
The remote control requires two AAA (RO3) batteries (not included). We recommend that you replace the batteries on a yearly basis or when the operation of the remote control becomes intermittent or unsatisfactory. Replace the original batteries with new AAA batteries. Do not mix old and new batteries or different types of batteries.
To replace the batteries:
1Press the lock tab of the battery holder and open the battery compartment.
2Place two AAA batteries in the battery holder, matching the + and – in the battery compartment.
3Close the battery holder.
Caution | • Use only the size and type of batteries |
| specified. |
| • Make sure that you follow the correct |
| polarity as indicated in the battery |
| compartment. Reversed batteries may |
| damage the device. |
| • Do not mix different types of batteries |
| together (for example, Alkaline and |
| |
| ones. |
| • If the remote is not to be used for a |
| long period of time, remove the |
| batteries to prevent damage or injury |
| from possible battery leakage. |
| • Do not try to recharge batteries not |
| intended to be recharged. They can |
| overheat and rupture. |
|
|
Setting your recorder’s RF output channel
If you use the RF cable connection to connect the recorder to your TV, you must set the recorder’s RF channel output and tune your TV to this channel to be able to see the Setup Wizard and various menus used in setting up your recorder.
To set the recorder’s RF output channel:
1When the recorder is turned off, press and
hold CH ( 
/ 
) on the front panel for more than five seconds. [RF03] or [RF04] appears in the display window.
2Press CH ( 
/ 
) to change the RF output channel (RF03 or RF04).
3Tune the TV to this channel.
Using your recorder
Turning your recorder on and off
To turn your recorder on and off:
1Plug the power cord into an electrical outlet.
2Press the POWER button to turn on your recorder.
3Press the POWER button again to turn off your recorder.
Initial Setup Wizard
The first time you turn on the recorder, the Initial Setup Wizard opens so you can set the language, channels, and clock.
To set up your recorder with the Setup Wizard:
1Use 
/ 
to select a language for the Setup menu and
ENTER.
2Check your antenna connections, then press
.
3Press ENTER to begin the channel search.
4Select Auto or Manual to set the clock, then press ENTER.
Auto
•Press 
/ 
to choose your Time Zone.
•Press 
to choose the Daylight Savings
option. Press 
/ 
to choose Auto, ON, or OFF.
•Press ENTER to confirm your setting.
Manual
•Enter the necessary information for year, date, and time.
/
(left/right): Moves the cursor to the previous or next column.
/ 
(up/down): Changes the setting at the current cursor position.
•Press ENTER to confirm your setting. 5 Press ENTER to exit the menu.
Note You can reset the Initial Setup Wizard from the Factory Set option in the setup menu (see “General Settings” on page 14).
Playing a disc
To play a disc:
1Press DVD to switch control to the DVD deck.
2Press OPEN/CLOSE (
) to open the disc tray.
3Load the disc into the tray, with the playback side down.
4Press OPEN/CLOSE (
) to close the tray. Playback starts automatically. If playback
does not start, press PLAY ( 
) or start the playback using the HOME menu.
11 |