Integra Turning On the DTR-8.4with the Remote Controller, Connecting the DTR-8.4—Continued

DTR-8.4_En.book Page 38 Thursday, October 16, 2003 11:09 AM

Connecting the DTR-8.4—Continued

Turning On the DTR-8.4

1

Standby/On

Master Volume

Standby

Direct/

Zone 2 (GRN)

Pure Audio

Audio

Rec

(RED)

DVD

Video 1

Video 2

Video 3

Video 4

Video 5

Tape

Tuner

Phono

CD

Net Audio

Pure Audio U psampling

Selector

Display

VCR 1

VCR 2

Push To Open

DTR-8.4

Standby/On

1	Press the [Standby/On] button to turn on the DTR-8.4.
	The display lights up and the Standby indicator goes off.
	Press the Standby/On button again to enter Standby.

Note:

Turning on the DTR-8.4 may cause a momentary power surge that might interfere with other electrical equipment on the same circuit. If this is a problem, plug the DTR-8.4 into a different branch circuit.

Turning On the DTR-8.4 with the Remote Controller

2

1

The DTR-8.4 must be in Standby mode for the following procedure to work.

1

2

Press the scroll wheel.

“AMP” appears on the remote controller’s display. This is the mode for controlling the DTR-8.4.

Press the [On] button to turn on the DTR-8.4.

To set the DTR-8.4 to Standby, press the [Standby] button.

Note:

• Any components connected via will also be turned on when the remote controller’s [On] button is pressed again.

38