Integra DTR-8.4 Specifying the TV System Australian model only, Basic Setup-Continued

DTR-8.4_En.book Page 49 Thursday, October 16, 2003 11:09 AM

Basic Setup—Continued

Changing the Remote Controller’s Control ID

This section explains how to change the remote control- ler’s ID. You may need to change this if the DTR-8.4’s remote controller interferes with other Integra/Onkyo components located in the same room.

Note:

If you change the remote controller’s ID, be sure to select the same ID on the DTR-8.4 (page 48). The default ID for both the DTR-8.4 and remote controller is 1.

1	Hold down the remote control-
	ler’s [Custom] button for more
	than three seconds.
	The remote controller enters Custom
	mode.

2 Roll the scroll wheel to select “SETUP” menu, and then press the scroll wheel.

3 Roll the scroll wheel to select ID menu, and then press the scroll wheel.

4 Roll the scroll wheel to select an ID—1 (default), 2, or 3—and then press the scroll wheel.

Select the same ID as that set on the

DTR-8.4.

Specifying the TV System (Australian model only)

This section explains how to specify the TV system used in your area. (This setting is not available on the Ameri- can model.)

1	Press the scroll wheel, and then
	press the [Setup] button.
	The main menu appears onscreen.

2 Use the Up/Down []/[ ] but- tons to select “0. Hardware Setup,” and then press the [Enter] button.

The Hardware Setup menu appears.

3	Use the Up/Down [ ]/[ ] but-
	tons to select “4.TV Format,” and

then press the [Enter] button.

The TV Format menu appears.

0-4.TV Format

a.TV Format

:Auto

Quit:[SETUP]

4	Use the Left/Right [ ]/[ ] but-
	tons to select:

Auto: The DTR-8.4 automatically detects the TV system.

PAL: Select if the TV system in your area is PAL.

NTSC: Select if the TV system in your area is NTSC.

49