Integra DTR-8.4 Remote Setup, Specifying the Location of an IR Receiver, Basic Setup—Continued

DTR-8.4_En.book Page 48 Thursday, October 16, 2003 11:09 AM

Basic Setup—Continued

Remote Setup

Specifying the Location of an IR Receiver

This section explains how to specify the location when using a commercially available IR receiver.

1	Press the scroll wheel, and then
	press the [Setup] button.
	The main menu appears onscreen.

2	Use the Up/Down [ ]/[ ] but-
	tons to select “0. Hardware

Setup,” and then press the [Enter] button.

The Hardware Setup menu appears.

3 Use the Up/Down []/[ ] but- tons to select “3. Remote Setup,” and then press the [Enter] button. The Remote Setup menu appears.

0-3.Remote Setup
a.Position	:Main
b.Remote ID	:1
	Quit:[SETUP]

4	Use the Up/Down [ ]/[	] but-
	tons to select “a. Position,” and
	then use the Left/Right [	]/[ ]
	buttons to select:

Main: Select if the IR receiver is located in the main room.

Zone 2: Select if the IR receiver is located in, and will be used to control Zone 2.

5	Press the [Setup] button.
	The setup menu closes.

Changing the DTR-8.4’s Remote Control ID

This section explains how to change the DTR-8.4’s remote control ID. You may need to change this if the DTR-8.4’s remote controller interferes with other Inte- gra/Onkyo components located in the same room.

Note:

If you change the DTR-8.4’s remote control ID, be sure to select the same ID on the remote controller (page 49). The default ID for both the DTR-8.4 and remote control- ler is 1.

1	Press the scroll wheel, and then
	press the [Setup] button.
	The main menu appears onscreen.

2 Use the Up/Down []/[ ] but- tons to select “0. Hardware Setup,” and then press the [Enter] button.

The Hardware Setup menu appears.

3 Use the Up/Down []/[ ] but- tons to select “3. Remote Setup,” and then press the [Enter] but- ton.

The Remote Setup menu appears.

4	Use the Up/Down [ ]/[	] but-
	tons to select “b. Remote ID,” and
	then use the Left/Right [	]/[ ]

buttons to select an ID: 1 (default), 2, or 3.

5	Press the [Setup] button.
	The setup menu closes.

Note:

• This procedure can also be performed by using the DTR-8.4’s [Setup] button, []/[ ]/[]/[ ] but- tons, and [Enter] button.

48

Note:

• This procedure can also be performed by using the DTR-8.4’s [Setup] button, []/[ ]/[]/[ ] but- tons, and [Enter] button.