Integra DTR-8.4 Advanced Operation—Continued, Selecting the Multichannel Input, Notes

DTR-8.4_En.book Page 64 Thursday, October 16, 2003 11:09 AM

Advanced Operation—Continued

Selecting the Multichannel Input

This section explains how to select the multichannel ana- log input for playback.

1, 2

1

4

2

1	Press the [Input] button, and then
	roll the scroll wheel to select
	“DVD.”

2	Press the scroll wheel, and then
	press the [Audio SEL] button
	repeatedly to select “Multich. ”

3	Start playback on your DVD
	player.
4	To adjust the volume, use the
	Master Volume control, or the
	remote controller’s [VOL] button.
	The volume can be set from 0 to 100.

Notes:

•This procedure can also be performed by using the DTR-8.4’s input selector buttons and [Audio Selector] button.

•You can only use the Direct and Pure Audio listening modes with the multichannel input. If another listen-

64

ing mode is being used when the multichannel input is selected, that listening mode is cancelled.

•Press the [Surround] button to adjust a bass and treble effect (“Tone On” appears on the display).

Adjusting the Volume of Individual Speakers for the Multichannel Input

While using the multichannel input, you can adjust the volume of each speaker individually.

1

1 2

1	Press the scroll wheel, and then
	use the [CH SEL] button to select
	each speaker.
	Speakers are selected in the following
	order.
	Front left	Center	Front right
	Subwoofer		Surr right
	Surr left	Surr back	Surr back
		left	right
2	Use the [Level–] and [Level+] but-

tons to adjust the volume.

The volume can be adjusted from –12 to +12 dB in 1 dB steps (–30 to +12 dB for the subwoofer).

Note:

•You cannot select speakers that are set to No or None on the Speaker Configuration menu (see page 41).

•These settings are not the same as the level calibration settings on page 44.

•These settings affect only the multichannel input source and have no effect on other input sources.