Integra DTR-8.4 Setting the Surr Back/Zone 2 Outputs, 1 2, 2–4 1, Zone 2-Continued

DTR-8.4_En.book Page 86 Thursday, October 16, 2003 11:09 AM

Zone 2—Continued

Setting the Surr Back/Zone 2 Outputs

This section explains how to set the PRE OUT SURR BACK/ZONE 2 outputs and the SURR BACK/ZONE 2 SPEAKERS terminals for use as surround back outputs or Zone 2 outputs.

1

2, 3

2–4

1, 5

4

5

Use the Left/Right []/[ ] but- tons to select:

Surr Back: Use the SURR BACK/ ZONE 2 outputs (SPEAKERS and PRE OUT) as surround back outputs. Select this option when connecting a receiver/integrated amp in Zone 2 (see page 84).

Zone 2: Use the SURR BACK/ ZONE 2 outputs (SPEAKERS or PRE OUT) for Zone 2.

Select this option when connecting a power amp or only speakers in Zone 2 (see page 84).

Press the [Setup] button.

The setup menu closes.

Note:

1	Press the scroll wheel, and then
	press the [Setup] button.
	If the Basic menu appears, use the
	Down [ ] button to select Advanced
	Menu, and press the [Enter] button to
	display the Advanced menu.
2	Use the Up/Down [ ]/[ ] but-
	tons to select “0. Hardware

Setup,” and then press the [Enter] button.

The Hardware Setup menu appears.

3	Use the Up/Down [ ]/[ ] but-
	tons to select “2. Surr Back/
	Zone2,” and then press the
	[Enter] button.
	The Surr Back/ Zone2 menu appears.
	0-2.Surr Back/Zone2
	a.Surr Back/Zone2
	:Surr Back

•When the SURR BACK/ZONE 2 outputs (SPEAK- ERS and PRE OUT) are set to Zone 2, listening modes that need surround back speakers (i.e., Dolby Digital EX, DTS-ES, and THX Surround EX) are not avail- able.

•This procedure can also be performed by using the

DTR-8.4’s [Setup] button, []/[ ]/[]/[ ] but- tons, and [Enter] button.

Quit:[SETUP]

86