Mechanical Requirements
Proper seating
3.5Markings
R
All markings required in this section must be able to withstand a temperature of 240° C for 40 seconds (minimum) typical of a reflow profile for solder material used on the socket, as well as any environmental test procedure outlined in Section 5.
3.5.1Name
mPGA604 (font type is Helvetica Bold – minimum 6 point).
This mark shall be molded or Laser Marked into the processor side of the socket housing.
Manufacturer’s insignia (font size at supplier’s discretion).
This mark will be molded or laser marked into the socket housing. Both marks must be visible when first seated in the motherboard. Any request for variation from this marking requires a written description (detailing size and location) to be provided to Intel for approval.
3.5.2Lock (Closed) and Unlock (Open) Markings
The universal symbols for ‘Lock’ and ‘Unlock’ are to be marked on the socket in the appropriate positions. Clear indicator marks must be located on the actuation mechanism that identifies the lock (closed) and unlock (open) positions of the cover as well as the actuation direction. These marks should still be visible after a package is inserted into the socket.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Lock (closed) | Unlock (open) | ||||
|
|
|
|
|
|
3.5.3Lot Traceability
Each socket will be marked with a lot identification code that will allow traceability of all components, date of manufacture (year and week), and assembly location. The mark must be placed on a surface that is visible when mounted on a printed circuit board. In addition, this identification code must be marked on the exterior of the box in which the units ship.
14 | mPGA604 Socket Design Guidelines |