Intel S845WD1-E manual Memory, Dimm Installation Guidelines, Installing DIMMs

Memory

The SE845WD1-E server board contains two 184-pin DIMM sockets and supports up to two DDR SDRAM DIMMs. The minimum supported memory configuration is 64 MB and the maximum configurable memory size is a 2 GB stacked un-buffered DDR200/266 ECC DIMM.

✏NOTE

Only low profile DIMMs can be supported in a 1U server chassis.

Check the Intel Customer Support website for the latest tested memory list:

http://support.intel.com/support/motherboards/server/SE845WD1-E

DIMM Installation Guidelines

All memory components and DIMMs used with the S845WD1-# server board must comply with the DDR specifications. These include the following:

•Intel® Spec Addendum Rev 0.9 for the JEDEC DDR200/266 Unbuffered DIMM Specification

•DDR200/266 Unbuffered DIMM System-level Validation Results

You can access these documents through the Internet at:

http://www.intel.com/technology/memory/

Installing DIMMs

To install DIMMs, follow these steps:

1.Observe the safety and ESD precautions at the beginning of this chapter.

2.Turn off all peripheral devices connected to the server. Turn off the server and disconnect the AC power cord.

3.Remove the server’s cover and locate the DIMM sockets (see Figure 5).

Server Board Installation and Upgrading 43