Intel S845WD1-E manual Exit Menu, Atapi Cdrom Drives Submenu

ATAPI CDROM Drives Submenu

To access this menu, select Boot on the menu bar, then ATAPI CDROM Drives.

Maintenance Main Advanced Security Power Boot Exit

Boot Device Priority

Hard Disk Drives

Removable Devices

ATAPI CDROM Drives

The submenu represented in Table 34 is for setting ATAPI CDROM drive priority.

Table 34. ATAPI CDROM Drives Submenu

Feature	Options	Description
1st ATAPI CDROM Drive	Dependent on installed	Specifies the boot sequence from the available
(Note)	ATAPI CDROM drives	ATAPI CDROM drives. To specify boot sequence:
		1. Select the boot device with <↑> or <↓>.
		2. Press <Enter> to set the selection as the intended
		boot device.

Note: This boot device submenu appears only if at least one boot device of this type is installed. This list will display up to four ATAPI CDROM drives, the maximum number of ATAPI CDROM drives supported by the BIOS.

Exit Menu

To access this menu, select Exit from the menu bar at the top of the screen.

Maintenance Main Advanced Security Power Boot

Exit

The menu represented in Table 35 is for exiting the BIOS Setup program, saving changes, and loading and saving defaults.

Table 35. Exit Menu

Feature	Description
Exit Saving Changes	Exits and saves the changes in CMOS SRAM.
Exit Discarding Changes	Exits without saving any changes made in the BIOS Setup program.
Load Setup Defaults	Loads the factory default values for all the Setup options.
Load Custom Defaults	Loads the custom defaults for Setup options.
Save Custom Defaults	Saves the current values as custom defaults. Normally, the BIOS reads the
	Setup values from flash memory. If this memory is corrupted, the BIOS reads the
	custom defaults. If no custom defaults are set, the BIOS reads the factory
	defaults.
Discard Changes	Discards changes without exiting Setup. The option values present when the
	server was turned on are used.

Configuration Software and Utilities 79