Installing the Server Board
Refer to your chassis manual for instructions on installing the server board. Eight screws secure the server board to the chassis. Figure 7 shows the locations of the mounting screw holes.
✏NOTES
You will need a Phillips (#2 bit) screwdriver.
Refer to Page 93 for regulatory requirements and installation instructions and precautions.
WARNING
Only qualified technical personnel should attempt this procedure. Disconnect the server from its power source before performing the procedures described here. Failure to disconnect the power before you open the server can result in personal injury or equipment damage.
OM14283
Figure 7. Location of the Mounting Screw Holes
46 | Intel Server Board |
