Intermec PL4 manual To test the POP3 e-mail printing

5Set the poll frequency of the printer. The poll frequency determines how often the printer checks for new e-mail. It is recommended that you choose a value greater than 10 seconds; otherwise the printer may be unresponsive to other activity. Set the poll frequency using the following command:

! U1 SETVAR “ip.pop3.poll” “xxx”

where “xxx” is the desired time in seconds for how often the printer should check for new e-mail.

6Enable POP3 via the command:

! U1 SETVAR “ip.pop3.enable” “on”

7If you want the printer to display the headers of the e-mail messages when they are printed, issue the following command:

! U1 SETVAR “ip.pop3.print_headers” “on”

8Test the POP3 e-mail printing. For help, see the next procedure.

To test the POP3 e-mail printing

1Print a configuration label and check that the POP3 line reads on. For help, see “Verifying the Printer Is Working” earlier in this guide.

2From your PC, send an e-mail to the POP3 mail account that the printer is monitoring.

3Turn the printer off and then back on.

Within 10 seconds, the printer should print out the e-mail message you just sent.

EasyCoder PL4 Printer User’s Guide 41