Intermec PL4 manual Charging the Battery, Using the Single Battery Charger

Belt clip

Charger

jack Battery PL4U006.eps

4Press the battery into the printer until it locks in place.

When the battery is first installed, the Control Panel indicators may briefly turn on and then go off which indicates the battery is not fully charged. For help, see “Using the Single Battery Charger” and “Understanding the Control Panels” later in this guide.

Charging the Battery

This section explains how to use the following chargers:

•Single battery charger (P/N AT15759-1) that comes with an AC contact adapter for the U.S.A. (110V). You can also order a set of international contact adapters (P/N AN16740-1).

•4-pack battery charger (P/N AT16305-2) that is designed to charge up to four PL4 batteries simultaneously. You must remove the batteries from the printer to charge them.

Using the Single Battery Charger

Using the single battery charger, you can charge the battery while it is in the printer or when it is removed. If the battery is in the printer, the printer must be turned off to charge the battery.

8 EasyCoder PL4 Printer User’s Guide