Invacare 1026793 manual Adjusting Calfpads, Installing Adjustable Angle Flip-Up Footplate Hinge

SECTION 4—FRONT RIGGINGS

Adjusting Calfpads

Calfpad

NOTE: For this procedure, refer to FIGURE 4.5.

1.To adjust the calfpad, turn pad towards the outside of the wheelchair.

2.Slide the calfpad up or down until the desired position is obtained.

3.To secure the calfpad, turn the calfpad towards the inside of the wheelchair.

Adjust Calfpad	Secure Calfpad
FIGURE 4.5	Adjusting Calfpads

Installing Adjustable Angle Flip-Up Footplate Hinge

NOTE: For this procedure, refer to FIGURE 4.6.

NOTE: This procedure is for individual adjustable angle footrests only.

1.Position the adjustable angle flip-up footplate hinge on the footrest support tube at the desired height.

2.Position the hardware on the footrest support (FIGURE 4.6).

3.Flip the footplate hinge to the UP position.

NOTE: The footplate hinge will fall to the

DOWN position.

4.Tighten the socket screw and locknut that secure the footplate hinge to the footrest support until the footplate hinge remains in the UP position.

5.Check the up and down motion of the footplate hinge to make sure the user of the wheelchair can operate the footplates easily.

NOTE: If the footplate's motion is too tight, loosen the socket screw and locknut approximately

1/4-turn.

	Footrest
Locknut	Support
	Tube
Footplate	Socket Screw
Hinge

NOTE: If the footplate's motion is too loose, tighten socket screw and locknut approximately

1/4-turn.

FIGURE 4.6 Installing Adjustable Angle Flip-

Up Footplate Hinge

Part No 1026793 31 Xtra™