Invacare 1026793 manual Installing/Removing the Chest Positioning Strap

SECTION 5—BACK

Installing/Removing the Chest Positioning Strap

NOTE: For this procedure, refer to FIGURE 5.3.

1.Remove the two (2) mounting screws and washers securing the back upholstery to the back cane.

2.Do one (1) of the following:

A.To install the chest positioning strap, proceed to STEP 3.

B.Remove the two (2) existing chest positioning strap halves from the back upholstery.

3.Secure the two (2) halves of the new chest positioning strap together.

4.Align the mounting hole on one (1) end of the NEW chest positioning strap with the mounting hole on the back upholstery and back cane.

5.Secure the new chest positioning strap and back upholstery to the back cane with one (1) mounting screw and washer. Torque to 20-25 in./lbs.

Secure these ends together

Chest Positioning Strap Half

Chest
Positioning		Washer
Strap Half
		Back
	Upholstery
	Washer	Mounting
	Back Cane	Screws

NOTE: Only Hook and Loop style chest positioning strap shown. Auto style chest positioning strap attaches the same way.

FIGURE 5.3 Installing/Removing the Chest

Positioning Strap

NOTE: Ensure strap is oriented properly and not twisted when installing.

6. Repeat STEPS 4-5 for opposite side of new chest positioning strap.

NOTE: Only hook and loop style chest positioning strap shown. Auto style chest positioning strap attaches the same way.

Xtra™ 36 Part No 1026793