SECTION
Adjusting the Back Angle
NOTE: For this procedure, refer to FIGURE 5.2.
NOTE: This procedure applies to adjustable angle backs only.
NOTE: The back adjusts to four (4) positions in five 5° degree increments from 0° to 15°.
1.Remove the two (2) back angle adjustment screws and locknuts.
2.Reposition the back to the desired angle.
3.Ensure the upper back angle mounting hole is aligned with one (1) of the four (4) upper angle adjustment holes.
4.Install one (1) of the back angle adjustment screws through the upper back angle mounting hole and the desired upper angle adjustment hole.
5.Install the remaining back angle adjustment screw through the lower back angle mounting hole and the desired lower angle adjustment hole.
6.Secure each back angle adjustment screw with a locknut. Torque locknut to
Back Cane | Upper Back Angle |
| |
|
| ||
| Mounting Hole | Detail "A" - back | |
Back Angle |
| ||
| angle mounting holes | ||
Adjustment |
|
| |
Screw |
| Upper | |
| Locknut | ||
| 0° | ||
|
| ||
Locknut |
| 5° | |
| 10° | ||
|
| ||
|
| 15° | |
|
| Lower | |
|
| 0° | |
Lower Back | Back Angle | 5° | |
10° | |||
Angle Mounting | Adjustment | ||
15° | |||
Hole | Screw | ||
|
FIGURE 5.2 Adjusting the Back Angle
Part No 1026793 | 35 | Xtra™ |
