Invacare 1026793 manual Arms, Installing the Half Arm, NOTE For this procedure, refer to FIGURE

SECTION 7—ARMS

SECTION 7—ARMS

WARNING

After any adjustments, repair or service and before use, make sure all attachment hardware is tightened securely - otherwise, injury or damage may result.

DO NOT attempt to lift or tilt a wheelchair by using any removable (detachable) parts. Lifting by means of any removable (detachable) parts of a wheelchair may result in injury to the user or damage to the wheelchair.

Installing the Half Arm

NOTE: For this procedure, refer to FIGURE 7.1.

1.Position the arm socket on the wheelchair frame.

2.Position the top coved washer between the arm socket and the wheelchair frame.

NOTE: The slot in the arm socket is used with either the top or the bottom mounting holes in the arm socket depending on the half arm height desired.

3.Install the top hex screw through the wheelchair frame, coved washer, the mounting hole in the arm socket and washer. Loosely tighten with locknut.

4.Position the bottom coved washer between the arm socket and the wheelchair frame.

5.Install the bottom hex screw through the wheelchair frame, coved washer, the slot in the arm socket and washer. Loosely tighten with locknut.

6.Securely tighten the two (2) hex screws and locknuts that secure the arm socket to the wheelchair frame.

7.Install a washer onto the hex screw and insert the hex screw into the arm socket to one

(1) of three (3) positions depending on desired height.

8.Install a washer on the end of the hex screw and securely tighten with locknut.

9.Install the half arm into the arm socket.

Xtra™ 42 Part No 1026793