Invacare 1026793 manual Adjusting Half Arm Height, Installing the Half Arm

SECTION 7—ARMS

	Half Arm	Coved
Locknuts	Arm	Washers
	Socket
		Wheelchair Frame

	TOP Hex
Washers	Screw
	BOTTOM
Hex Screw	Hex Screw

FIGURE 7.1 Installing the Half Arm

Adjusting Half Arm Height

NOTE: For this procedure, refer to FIGURE 7.2.

1.Remove the half arm from the arm socket.

2.Remove the hex screw, two (2) washers and locknut mounted in the arm socket that determine the half arm height.

3.Reposition hex screw and one (1) washer to one (1) of three (3) positions in the arm socket depending on the desired height.

4.Retighten the hex screw and washer to the arm socket with the remaining washer and locknut.

5.Reinstall the half arm into the arm socket.

6.Repeat STEPS 1-5 for the opposite side, if necessary.

NOTE: If desired height is still not obtainable, refer to Installing the Half Arm on page 42, to reposition the arm socket on the wheelchair with the top hex screw in the top mounting hole of the arm socket and the bottom hex screw in the slot of the arm socket.

Half	Arm Socket
Arm
Locknut	Three (3)
Washer	Mounting
	Positions
Hex Screw

FIGURE 7.2 Adjusting Half Arm Height

Part No 1026793 43 Xtra™