Manuals / Invacare / Personal Care / Mobility Aid

Invacare 1026793 Installing Fabric Clothing Guards, NOTE For this procedure, refer to FIGURE

Models: 1026793

1 60

Download 60 pages 35.02 Kb

Page 40

Installing Fabric Clothing Guards

SECTION 6—SEAT

Rearmost

Mounting Screws

Rear Edge of

Seat

Seat Rail

Seat Positioning

Strap Half

Seat Positioning

Strap Half

NOTE: Only Hook and Loop style seat positioning strap shown. Auto style seat positioning strap attaches the same way.

FIGURE 6.3 Installing/Removing Seat Positioning Strap

Installing Fabric Clothing Guards

NOTE: For this procedure, refer to FIGURE 6.4.

1.Remove the seat cushion, if necessary.

2.Secure the fastening straps of the fabric clothing guards to the fastening straps on the seat upholstery.

3.Reinstall the seat cushion, if necessary.

4.Remove the two (2) phillips screws that secure the back upholstery to the back canes.

Fabric Clothing

Guard

Fastening

Strap

5.Position the D-rings on the mounting holes in the back canes.

6.Reinstall the two (2) phillips screws. Torque to 20-25 in./lbs.

7.Run the nylon cord evenly through the two (2) D-rings.

8.Run the nylon cord through the cord lock.

9.Push star wheel into cord lock to hold the nylon cord in place.

10.Tie a knot in the nylon cord and cut the excess, if desired.

		Seat Upholstery
	Card Lock
	Phillips Screw	Phillips
	Phillips Screw	Screw
	D-ring	Screw
	D-ring	D-ring
		D-ring
		Star Wheel
		Nylon Card

FIGURE 6.4 Installing Fabric Clothing

Guards

Xtra™

40

Part No 1026793

Image 40

Invacare 1026793 manual Installing Fabric Clothing Guards, NOTE For this procedure, refer to FIGURE

Contents

Xtra Owner’s Operator and Maintenance ManualDEALER This manual MUST be given to the user of the wheelchair Xtra TABLE OF CONTENTS TABLE OF CONTENTSSECTION 2-SAFETY/HANDLING OF WHEELCHAIRS SECTION 3-SAFETY INSPECTION/TROUBLESHOOTINGTABLE OF CONTENTS TABLE OF CONTENTSInstalling/Removing/Adjusting the Footrests Adjusting 70 MFX and 90 FootrestsTABLE OF CONTENTS TABLE OF CONTENTSSECTION 7-ARMS SECTION 8-WHEELSREGISTER YOUR PRODUCT TABLE OF CONTENTSLIMITED WARRANTY Installing Amputee AttachmentsPRODUCT REGISTRATION FORM Cut Along LineFold hereInvacare Product Registration Form Fold here Cut Along Line Fold herePlease Seal with Tape Before Mailing SPECIAL NOTES LABEL LOCATIONS LABEL LOCATIONSManual Title TYPICAL PRODUCT PARAMETERS TYPICAL PRODUCT PARAMETERSXTRA SECTION 1-GENERAL GUIDELINES StabilityNOTE When changes to the left the chart and refer to theRepair and Service Information Operating InformationALWAYS keep hands and fingers clear of moving parts to avoid injury Weight Limitation Weight TrainingTire Pressure SECTION 2-SAFETY/HANDLING OF WHEELCHAIRS Stability and BalanceCoping with Everyday Obstacles A Note to Wheelchair AssistantsTipping NOTE For this procedure, refer to FIGURENOTE For this procedure, refer to FIGURE Tipping - CurbsStairways Transferring To and From Other Seats NOTE For this procedure, refer to FIGUREPercentage of Weight Distribution Adjusting the Wheelbase for StabilityNOTE For this procedure, refer to FIGURE NOTE For this procedure, refer to FIGUREReaching, Leaning and Bending - Forward Reaching, Bending - BackwardNOTE For this procedure, refer to FIGURE NOTE For this procedure, refer to FIGURESECTION 3-SAFETY INSPECTION/ TROUBLESHOOTING Safety Inspection ChecklistsInspect/Adjust Weekly Inspect/Adjust Monthly SECTION 3-SAFETY INSPECTION/TROUBLESHOOTINGInspect/Adjust Periodically Troubleshooting MaintenanceCHAIR VEERS LEFT/RIGHT SLUGGISH TURN/PERFORMANCESuggested Maintenance Procedures Installing/Removing/Adjusting the Footrests SECTION 4-FRONT RIGGINGSNOTE For this procedure, refer to FIGURE NOTE Make sure to note the position of the washers before disassemblyAdjusting 70 MFX and 90 Footrests NOTE For this procedure, refer to FIGUREInstalling Elevating Legrests Raising/Lowering Elevating LegrestsNOTE For this procedure, refer to FIGURE NOTE For this procedure, refer to FIGUREAdjusting Calfpads Installing Adjustable Angle Flip-Up Footplate HingeNOTE For this procedure, refer to FIGURE NOTE For this procedure, refer to FIGUREAdjusting Adjustable Angle Flip-Up Footplates Depth AdjustmentAngle Adjustment NOTE For this procedure, refer to FIGUREHeel Loop Replacement Installing Impact Guards/Calf StrapNOTE For this procedure, refer to FIGURE NOTE For this procedure, refer to FIGUREAdjusting the Back Height SECTION 5-BACKNOTE For this procedure, refer to FIGURE NOTE Both back canes should be adjusted to the same adjustment holeAdjusting the Back Angle NOTE For this procedure, refer to FIGURENOTE This procedure applies to adjustable angle backs only Detail A - backInstalling/Removing the Chest Positioning Strap NOTE For this procedure, refer to FIGUREInstalling the Stroller Handles Installing and Removing a Seating SystemNOTE For this procedure, refer to FIGURE NOTE This procedure applies to ALL stroller handlesFolding/Unfolding the Wheelchair SECTION 6-SEATNOTE For this procedure, refer to FIGURE Installing/Removing Seat Positioning Strap Replacing Seat UpholsteryNOTE For this procedure, refer to FIGURE NOTE For this procedure, refer to FIGUREInstalling Fabric Clothing Guards NOTE For this procedure, refer to FIGUREInstalling Clothing Guards NOTE For this procedure, refer to FIGURESECTION 7-ARMS Installing the Half ArmNOTE For this procedure, refer to FIGURE Adjusting Half Arm Height NOTE For this procedure, refer to FIGUREUsing/Adjusting Dual Point Arms Adjusting Armrest HeightNOTE For this procedure, refer to FIGURE Removing ArmrestsInstalling/Removing T-Arms Replacing Dual Point Arm Pad/Clothing GuardsNOTE For this procedure, refer to FIGURE NOTE This procedure is for fixed height dual point arms ONLYAdjusting the T-Arms Adjusting T-Arm HeightNOTE For this procedure, refer to FIGURE Removing T-ArmsAdjusting T-Arm Width NOTE For this procedure, refer to FIGUREAdjusting T-Arm Depth NOTE For this procedure, refer to FIGURENOTE Additional positions are obtainable by turning the arm tube NOTE Desk length armAdjusting T-Arm Sockets NOTE For this procedure, refer to FIGURET-Arm T-Arm Clamp Hex Screws and Washer SlotAdjusting T-Arm Transfer Assists and/or Side Guards NOTE For this procedure, refer to FIGURERepairing/Replacing Pneumatic Tire/Tube Removing/Installing Rear WheelsSECTION 8-WHEELS NOTE For this procedure, refer to FIGUREPermanent Axles Adjusting Quick-Release Axles NOTE For this procedure, refer to FIGURELocking Pins Axle Mounting PlateInstalling Quad-Release Axles NOTE For this procedure, refer to FIGUREAdjusting Quad-Release Handles NOTE For this procedure, refer to FIGURENOTE For this procedure, refer to FIGURE In and/or OutAdjusting Forks NOTE For this procedure, refer to FIGURESECTION 9-WHEEL LOCKS/ANTI- TIPPERS Replacing/Adjusting the Wheel LocksNOTE For this procedure, refer to FIGURE Installing/Adjusting the Anti-Tippers Installing Anti-TippersAdjusting Anti-Tippers NOTE For this procedure, refer to FIGURENOTE For this procedure, refer to FIGURE Installing Amputee AttachmentsNOTE This will maintain the current rear seat to floor height LIMITED WARRANTY Canada