Page 2
TM-1020 Series Progressive Scan Shutter Cameras
1.2Features
•Miniature size and light weight
The printed circuit boards in the TM-1020 series have been arranged based on a new design philosophy. This creates modular electronics for the camera, giving it flexibility. In addition, the use of miniature solid-state components results in a compact, lightweight camera that is 44mm x 44mm x 64mm in dimensions, and weighs only 149 grams.
•Imager
The TM-1020 series uses a progressive-scan interline transfer CCD that has the following features:
-Resolution of 1008 x 1018 active pixels for excellent image quality.
-9.0 x 9.0 µm square pixels for precise dimensional measurement.
-High-speed electronic shutter capability for high dynamic resolution of moving objects and electronic iris control that eliminates the need for a mechanical shutter.
-Progressive-scan CCD eliminates interlace deterioration of image and increases ease of computer interface.
-High sensitivity and low noise at fast scanning. The 1” CCD has an excellent S/N ratio that is greater than 50dB.
-The CCD has a built-in microlens for increased quantum efficiency.
•Electronic shutter
The TM-1020 series has a substrate drain-type shutter mechanism which provides superb pictures at various speeds without smearing. A built-in manual shutter speed control selects the electronic shutter rate of 1/60 (non-async mode only), 1/125, 1/250, 1/500, 1/1,000, 1/2,000, 1/4,000, 1/8,000, or 1/16,000 second.
With VINIT high (5V), the CCD keeps discharging. With a negative pulse to VINIT, the camera resets and purges the charge momentarily. Then it starts integrating for the period of shutter control set by either an external pulse width or internal shutter control. Progressive scanning permits a full 1000 lines of vertical resolution, as compared to a conventional CCD camera which captures only half the vertical lines per shutter.
•Asynchronous reset
The TM-1020 series captures async reset images and provides single-shot video output with single FDV. This makes it simpler for an ordinary frame grabber to capture the async reset images. The TM-1020 series’s asynchronous reset is flexible and accepts external horizontal drive (HD) for phase locking. When the VINIT (5V) pulse is applied, it resets the camera's scanning and purging of the CCD.
The TM-1020A-15 has two modes to control the asynchronous reset and shutter speed:
-External VINIT with pulse width. The duration between pulse edges controls the shutter speed externally (No-delay shutter).
-Internal shutter speed control. The speed control varies from 1/125 to 1/16,000 sec. The video signal and FDV starts with internal V reset timing related to shutter speed.
The TM-1020-15 has three modes to control the asynchronous reset and shutter speed:
-External VINIT with pulse width. The duration between pulse edges controls the shutter speed externally.
-Internal shutter speed with Fast mode. The video signal has no delay from the reset tim- ing. (shutter speed range is 1/2,000 to 1/16,000 sec.)
