JAI TM-6710 operation manual Power Supply and Power Cable Setup, MDR 26-Pin Connector 0226-622VC

Page 7

Installation

FIGURE 5. MDR 26-Pin Connector (0226-622VC)

MDR 26-Pin Connector

(0226-622VC)

Pin#	Description	Pin#	Description
1	GND (shield)	14	GND (Shield)
2	X0-	15	X0+
3	X1-	16	X1+
4	X2-	17	X2+
5	Xclk-	18	Xclk+
6	X3-	19	X3+
7	SerTC+	20	SerTC-
8	SerTFG-	21	SerTFG+
9	VINIT (CC1-)	22	VINIT (CC1+)
10	INTEG (CC2+)	23	INTEG (CC2-)
11	CC3-	24	CC3+
12	CC4+	25	CC4-
13	GND (shield)	26	GND (Shield)

2.2.2Power Supply and Power Cable Setup

PULNiX recommends the following power supply:

PD-12UUP 110V AC/12V DC 1.2A power supply

If you are providing power through the 12-pin connector, the PD-12UUP power supply is available with the 12-pin mating connector already attached to the leads from the power supply. The PD-12UU power supply can be connected directly to the PULNiX power cable or via a terminal strip. If you choose direct wiring, note the following:

•The lead ends must be twisted together and tin-soldered for strength and electrical continuity.

•Use shrink tubing or a similar insulator to prevent exposed leads from touching.

•The +12V lead is marked with a red stripe or white lettering; be sure not to reverse the leads.

•All connections must be properly insulated to prevent shorting.

If using PULNiX power cables, such as the 12P-02S, etc., please refer to the pin-out diagram. The color-coded leads use Gray for Ground and Yellow for +12V DC.

FIGURE 6. 12P-02S Power Cable

		+12 V
	GND (Gray)
Male	Power (Yellow)
	Video Out (Red Coax)		}
	HD In (White Coax)
	VD In (Black Coax)

Monitor

Frame Grabber

Note: Make sure that the unused leads are not touching and that there is no possibility that the leads could short due to exposed wires.

TM-6710/6710CL High-Speed Progressive Scanning CCD Camera