Page 25
Installation
5.2.3Camera Link Cable
The 26CL-02-26 cable assembly has been standardized as the Camera Link cable. This cable has a 26- pin connector on both ends. This is a straight-through cable and the pin-out configuration is shown in Table 2 on page 24. Contact JAI for cable lengths other than 2 meters.
FIGURE 39. 3M Camera Link Cable
26 Position | | 26 Position |
High Density | Cable | High Density |
Mini D Ribbon | | Mini D Ribbon |
(MDR) Male Plug | | (MDR) Male Plug |
14 15 16 17 18 19 20 21 22 23 24 25 26
1 2 3 4 5 6 7 8 9 10 11 12 13
1 2 3 4 5 6 7 8 9 10 11 12 13
14 15 16 17 18 19 20 21 22 23 24 25 26
2X | 2X |
Thumbscrews | Thumbscrews |
Note: For CL versions, serial communication for camera control is accomplished by means of the Camera Link connector on the rear panel of the camera.
5.2.4Power Supplies and Power Cable Setup
5.2.4 (a) Power Supplies
The TM-4200CL camera requires 12V DC power that is obtained through the 12-pin connector located on the rear panel of the camera. JAI recommends the following power supplies:
PD-12UU | 100-240V AC/12V DC | 1.2A universal voltage power supply, |
| | US Plug |
PD-12UUP | PD-12UU with12-pin connector | US plug |
PD-12UE | PD-12UU | European plug |
PD-12UEP | PD-12UU with 12-pin connector | European plug |
For users providing power through the 12-pin connector, the PD-12P, PD-12UEP and PD-12UUP power supplies are available with the 12-pin mating connector already attached to the leads from the power supply. The PD-12UU and PD-12UE power supplies can be connected to the JAI power cable by means of a terminal strip or directly.
When wiring the PD-12UU and PD-12UE power supplies directly, please note the following:
•The lead ends must be twisted together and tin-soldered for strength and electrical continuity.
•Use shrink tubing or a similar insulator to prevent exposed leads from touching and shorting.
TM/TMC-4200CL Series Progressive Scan Cameras
