JAI TM/TMC-4200CL operation manual Digital I/O Connector, Camera Link Connector Pin # Description

Page 24

Installation

5.2.2 (b) Digital I/O Connector

The TM-4200 has a 26-pin connector on the rear panel to output Camera Link data. The connector pin- out is shown in Table 2 on page 24

FIGURE 37. 26-pin Camera Link Connector.

13 1

26		14
TABLE 2.	Connector and Pin-out Configurations
		Camera Link Connector
Pin #	Description	I/O	Pin #	Description	I/O
1	GND		14	GND
2	Tx OUT 0-	Out	15	Tx OUT 0+	Out
3	Tx OUT 1-	Out	16	Tx OUT 1+	Out
4	Tx OUT 2-	Out	17	Tx OUT 2+	Out
5	Tx CLK OUT -	Out	18	Tx CLK OUT+	Out
6	Tx OUT 3-	Out	19	Tx OUT 3+	Out
7	SerTC+	In	20	SerTC-	In
8	SerTFG-	Out	21	SerTFG+	Out
9	VINIT	In	22	VINIT+	In
10	Reserved	In	23	Reserved	In
11	EX-HD-	In	24	EX-HD+	In
12	EX-VD+	In	25	EX-VD-	In
13	GND		26	GND

Note: SerTC: Serial To Camera

SerTFG: Serial to Frame Grabber

5.2.2 (c) Analog Output Connector

The TM-4200CL has a BNC connector on the rear panel to output the analog video signal. Analog output is available to drive auto-iris lenses and troubleshooting.

Note: This analog signal is not an RS-170 (television format) signal that can be connected to a standard CCTV monitor.

FIGURE 38. BNC Connector.

TM/TMC-4200CL Series Progressive Scan Cameras