Roll-Out Rack
The
Open Position
Closed and Engaged Position
C
B
A
A. Slide rails
B. Sliding shelf
C. Center brace
To Insert Roll-Out Rack
1.Angle the rack assembly up and insert the back edge into the “V” cutout in the rack guides of the oven cavity.
2.Keep the rack lifted at an angle and push in until the back edge of the sliding rails (A) bypass the lower “V” cutout.
3.Angle the rack downward and continue to gently slide the assembly in until the center brace (C) bypasses the “V” cutout.
4.Raise rack assembly to flat position and gently push to the back of the oven until the back edge of the sliding rail drops.
5.Pull the rack assembly slightly forward until the front edge drops and the sliding rails are on the rack guide.
B
A
A. “V” cutout
B. Rack guide
6.
B
A
A. “V” cutout
B. Rack guide
To Remove Roll-out Rack
1.Push the sliding shelf in completely so that it is closed and engaged with the slide rails.
A
B
C
A. Sliding shelf
B. Slide rails
C.Rack
2.Using 2 hands, lift up on the front edge of the rack assembly. Slowly push the rack assembly to the back wall of the oven so the front edge of the sliding shelf sits on the rack guides on the side of the oven cavity. The front edge of the rack should be higher than the back edge.
3.Using 2 hands, lift up the back of the rack assembly so that the front and back are level on the rack guides.
4.Pull the rack assembly out.
To avoid damage to the sliding shelves, do not place more than 25 lbs (11.4 kg) on the rack.
Do not clean the
See the “General Cleaning” section for more information.
11