Jenn-Air SEG196 manual Surface Controls, Locations, To Set Controls

Surface Controls

To Set Controls

•Since the controls are a push-turn type, they must be pushed down before turning. To set (from the OFF position), push down on control knob and imme-

diately turn counterclockwise to the MTE position until burner ignites. After ignition, turn knob clockwise to desired setting.

•Igniter will continue to spark until knob is turned clockwise back to or past Hi position on knob.

Control		Locations				NOTE: When using		an AG200 surface
						burner	assembly		with	control
1.	Left rear surface		burner		or grill	locations #1 and #2, the control
2.	Left front surface		burner		or grill	knob	may	be	turned	to	a
3.	Right	rear surface		burner		position	lower than the Lo
4.	Right	front surface		burner		setting.	(The I.o		detent	is	set
						for the	grill	burner.)

1. 2.3. 4.

Suggested Control Settings

for Surface Burners

The size and type of cookware and the amount and type of food being cooke will influence the setting needed for best cooking results. The setting indicate(z--

should serve

as a guide while

you

become familiar with your cooktop.

Use

the

Hi

flame

setting

to

quickly

bring

__

foods

to a boil or to begin

a cooking

opera-

_,(_.t,__)(_(fi_)

tion.

Then reduce

to

a lower

setting

to

con-

_._.v,,._,_._"

tinue cooking. Never leave food unattended

over a Hi flame setting.

Med setting is used to continue a cooking

operation.

Food

will

not

cook

any

faster

f

_

when

a

Hi

flame

setting

is used

than

that

_,,,_

needed to maintain a gentle boil. Remember,

water boils at the same temperature whether

boiling gently or vigorously.

Use Lo setting to keep food at serving

temperatures

without

further

cooking.

You

_

_

may find that some cooking may take place

if the

cookware is covered.

_.__

14