Jenn-Air SEG196 manual ofCleaningYour RangeOther Parts, Control Knobs, Control Dial Area, Igniters

Models: SEG196

1 51
Download 51 pages 45.47 Kb
Page 22
Image 22
ofCleaningYour RangeOther Parts

ofCleaningYour RangeOther Parts

Control Knobs

The knobs on the control panel can be removed with the controls in the OFF position. Pull each knob straight from the shaft. Wash knobs in warm soapy water or dishwasher; do not use abrasive cleansers or materials. To replace each knob, match flat part of knob opening with the flat of the shaft, returning in OFF position.

IMPORTANT: Never use a metal blade to pry knob off. If knob cannot be easily removed, tuck the folds of a cloth dishtowel under the knob skirt and pull the towel upward with steady, even pressure.

Control Dial Area

Use mild cleansers, such as soapy water, glass cleaners or mild liquid sprays, such as 409. Wipe with sponge, damp cloth or paper towel. Do not scrub with S.O.S. pads or abrasive cleansers.

Clock Control Surface

Wipe with paper towels dampened with soapy water or glass cleaner. Do not scrub with S.O.S. pads or abrasive cleansers.

Igniters

It is important to keep igniter port openings on burners clear and free of obstructions to avoid ignition failure and possible gas buildup. If the port openings are blocked, use a toothpick to remove food particles.

The igniter cap and stem can be cleaned with warm soapy water and a plastic

scrubber. The wire electrode inside the cap can be cleaned with a small brush ._ Rinse and dry.

Surface Burner Assembly

The surface burner assembly can be cleaned with mild detergents and a plastic scrubber, or washed in the dishwasher. To prevent scratching the burner heads, do not use abrasive cleansers or scrubbing pads. Do NOT clean in a self-clean oven.

Note: Check to be sure all ports are open. To open clogged ports, insert a toothpick directly into each port.

Glass on the Oven Door Front

Use any suitable glass cleaner or soapy water.

Oven Door Trim

i

J

Slightly dampen a cloth or paper towel with a nonabrasive cleanser, such as Bon Ami, soapy water or glass cleaner. Do not use excessive amounts of water or allow water to run down through the air vents in the door since this will cause streaks which will be visible through the glass door.

22

Page 22
Image 22
Jenn-Air SEG196 manual ofCleaningYour RangeOther Parts, Control Knobs, Control Dial Area, Clock Control Surface, Igniters