Jenn-Air SEG196 Oven Light Bulb, INInformation, To replace light builT, remaining two screws

Oven Light Bulb

Before replacing bulb, disconnect power to oven at the main fuse or circuit breaker

panel and at the electric receptacle. Be sure that the entire oven cavity including the light bulb is cool before attempting to remove.

To replace light builT:

1.Carefully remove the glass light lens and lens retainer by removing the two screws in the light

lens retainer using a phillips screwdriver. Note: The light lens is separate from the light lens retainer. The two pieces will drop down into your hands at the same time. Do NOT remove the

remaining two screws.

2.To obtain firm grasp on bulb, wear protective

rubber gloves. Remove by turning bulb to the left. Do not touch a hot oven light bulb with a damp cloth as bulb will break. Note: If the bulb does

break and you wish to remove it, be certain power

supply is disconnected and wear protective

gloves. You may contact your authorized Jenn- Air Service Contractor for service.

3.Replace bulb with a 40 watt oven-rated appliance bulb. Bulb with brass base is recommended to

prevent fusing of bulb into socket.

4.Place light lens inside of light lens retainer. Hold- ing the light lens and lens retainer in place, insert the two screws into the light lens retainer and tighten.

INInformation

Jenn-Air's ventilation system is designed to capture both cooking fumes and smoke from any place on the grill surface. If the system does not, these are some ducting installation situations to check:

•6" diameter round or 31/'4' x 10" rectangular ducting should be used for duct

lengths 10'-60'. 5" diameter round ducting must be used if the duct length is 10'or less.

•No more than three 90 ° elbows should be used. Distance between elbows should be at least 18".

•Recommended Jenn-Air wall cap should be used. Make sure damper moves freely when ventilation system is operating.

•There should be a minimum clearance of 6" for cooktop installed near a side wall.

If there is not an obvious improper installation, there may be a concealed problem such as a pinched joint, obstruction in the pipe, etc. Installation is the responsibility of the installer and questions should be addressed first by the installer. The installer should very carefully check the ducting installation instructions.

48