JVC DR-M10S 62 EN, When programmes overlap each other, ENTER, NOTE:, NOTE:, C Change the programme setting, E Engage the unit’s timer mode, ENTER, Press, Press &, Press rt

62 EN TIMER RECORDING (cont.)

&

PROG/CHECK

CABLE/SAT

TV DVD

STANDBY/ON

TV TV AV TV/CBL/SAT DVD

	VIDEO
	ABC	DEF	TV%
GHI	JKL	MNO
PQRS	TUV	WXYZ	PR
CANCEL	AUX	MEMO/MARK
SHOW VIEW/ PROG/CHECK SAT#			TIMER
VIDEO Plus+
TOP MENU		NAVIGATION
	ENTER
MENU			RETURN
PREVIOUS			NEXT
SLOW	PLAY/SELECT		SLOW
REC	STOP/CLEAR		PAUSE
REC MODE LIVE CHECK
SET UP			OPEN/
	DISPLAY ON SCREEN CLOSE

AUDIO SUBTITLE ANGLE	PROGRESSIVE
	SCAN

rt

ENTER

When programmes overlap each other

If “PROGRAM OVERLAPPED” appears, you have another programme overlapping the programme you have just made. Confirm with the arrow on “OK”, then press PROG/CHECK. Programme Check screen appears and conflicting programmes will be highlighted in pink.

Example: Programme 3 (you have just made) and Programme 4 overlap each other.A Confirm the overlapping programmes.Overlapping programmes appear on the TV screen.

NOTE:

If you do not mind this overlap, press PROG/CHECK to finish the timer programme setting. The programme with the lower programme number will be recorded and the other one will not be recorded correctly. If no changes are made for approximately 1 minute, the unit will return to the normal screen.

B Select the desired programme to be cancelled or changed.Press rt.To cancel the programmePress &.

●“THE TIMER PROGRAMMING SETTING WAS CANCELLED” appears on the TV screen for about 5 seconds, then the normal screen resumes.

To change the programme setting

Press ENTER.

C Change the programme setting.●Refer to steps D – J in “Manual Timer Programming” ( pg. 56).D Check if the conflict has been settled.

Press PROG/CHECK.

●Programme check screen appears.E Engage the unit’s timer mode.●Refer to step F in “Check, cancel and change programmes” ( pg. 61).

NOTE:

When any overlaps remain after deletion and modification of programmes, Programme Check screen remains showing the conflicting programmes. In such a case, repeat the procedure above until the conflict is solved.