EN 91

Connecting To A Dolby Digital Decoder Or An Amplifier With Built-in DTS

These instructions enable you to connect your unit to a Dolby Digital decoder or an amplifier with built-in DTS.

DIGITAL OUT

DIGITAL OUT

(COAXIAL)(OPTICAL)
To DIGITAL AUDIO input
Dolby Digitaldecoder or amplifier Back of unit with built-in DTSCoaxial cable (not provided)Optical cable (not provided)
Note for connection: Remove the protection cap from the optical cable.
Make connections.

Connect the unit and a Dolby Digital decoder or an amplifier with built-in DTS using either an optional optical cable or an optional coaxial cable.

NOTES:

●For Dolby Digital sound, set “DIGITAL AUDIO OUT” to “DOLBY DIGITAL/PCM”. ( pg. 93)

●For DTS sound, set “DIGITAL AUDIO OUT” to “STREAM/ PCM”. ( pg. 93)CAUTIONS:

●This unit has a dynamic range of more than 110 dB with regards to its Hi-Fi audio capability. It is recommended that you check the maximum level if you are going to listen to the Hi-Fi audio signals through a stereo amplifier. A sudden surge in the input level to the speakers may damage them.

●Some speakers and televisions are specially shielded to prevent television interference. If both are of the non-shielded type, do not place the speakers adjacent to the TV set as this can adversely affect the playback picture.

When you can’t switch the audio channel of a bilingual programme

When the unit is connected with a digital audio device using an optional optical cable and “DIGITAL AUDIO OUT” is set to “DOLBY DIGITAL/PCM”, it is not possible to switch the audio channel of a bilingual programme recorded on a DVD-RAM or DVD-RW (VR mode) disc. In this case, perform the following steps using the remote control to switch “DIGITAL AUDIO OUT” from “DOLBY DIGITAL/PCM” to “PCM ONLY”.

APress SET UP to access the Main Menu screen.

BPress w e to select “DVD SET UP”, then press ENTER. C Press w e to select “AUDIO OUTPUT”, then press

ENTER.

D Press rt to select “DIGITAL AUDIO OUT”, then press

ENTER.

E Press rt to select “PCM ONLY”, then press ENTER. ( pg. 93)

F Press SET UP to complete the setting.

G Press AUDIO to select the desired audio channel. ( pg. 34, “Audio Channel Selection”)