JVC DR-M10S 102 EN, Fine-TuningChannels Already Stored, Set Stations (B), NOTE:, C Perform fine-tuning, B Enter the new character, C Close the Confirmation screen, twice

102 EN SUBSIDIARY SETTINGS (cont.)

Set Stations (B)Set station names other than the ones registered in your unit.

Perform steps A and B of “Manual Channel Set” on page 99 to access the Confirmation screen and then perform steps A and B of “Set Stations (A)” ( pg. 101) before continuing.

A Select the character for station name.APress rt to select “ID”, then press ENTER. B Press ENTER twice.B Enter the new character.APress w e to locate the character insertion point.B Press rt to cycle through the characters (A–Z, 0–9,

–, f, +, I (space)) and stop when the desired character is indicated, then press e to enter.

C Enter the remaining characters the same way (maximum of 4).D After entering all characters, press w eto select “OK”, then press ENTER.

C Close the Confirmation screen.

Press SET UP twice.

NOTE:

The characters available for the station name (ID) are A–Z, 0–9, – , f, +, I (space) (maximum of 4).

Fine-Tuning Channels Already Stored

Perform steps A and B of “Manual Channel Set” on page 99 to access the Confirmation screen before continuing.

A Select the channel to fine-tune.APress rt w e to select the channel you want to fine- tune, then press ENTER.BPress ENTER twice.

B Access the Manual Channel Set screen.

Press ENTER. The Manual Channel Set screen appears.C Perform fine-tuning.APress rt to select “FINE”.BPress w e until the picture appears in its best quality.● Repeat steps A – C as necessary.D Close the Confirmation screen.Press SET UP three times.