28 EN

T-V LINK
F Check the result of the test.

If the satellite receiver’s channel number has been changed to the same one as you set in step E.

Press w e to move the arrow to “YES”, then press ENTER to finish the Sat Control Set mode.

If the satellite receiver’s channel number has not been changed correctly

Press w e to move the arrow to “NO”, then press ENTER. Then perform the procedure again from step D.

BRAND NAMECODE

 

 

JVC

73

AMSTRAD60, 61, 62, 63, 92
ASTON

97

CANAL SATELLITE

81

CANAL +

81

D-BOX

85

ECHOSTAR (VIA DIGITAL)

82

FINLUX

68

FORCE

89

GALAXIS

88

GRUNDIG64, 65, 102
HIRSCHMANN64, 78, 99
HUMAX

88

ITT NOKIA

68

JERROLD

75

KATHREIN70, 71, 96
LUXOR

68

MASCOM

93

MASPRO

70

NOKIA87, 94
PACE65, 67, 74, 86, 92, 97
PANASONIC74, 92
PHILIPS66, 84, 101
RADIX

78

RFT

69

SABA

97

SAGEM83, 90
SALORA

68

SAMSUNG

83

SIEMENS

64

SKYMASTER69, 98
TECHNISAT66, 100
THOMSON

97

TPS

83

TRIAX

91

WISI

64

 

 

NOTES:

●The Satellite Controller may not work with all types of satellite receiver.

●For some satellite receivers, you need to set its channel input mode to 2-digit.

●If your satellite receiver has more than two channel modes, be sure to set to “All Channel Mode”. For details, refer to the instruction manual of the satellite receiver.

●When selecting the satellite receiver’s channel ( step E), signals from the remote control may interfere with signals transmitted from the Satellite Controller. In this case, move the remote control as close to the unit’s infrared beam receiving window as possible.

T-V Link Functions

When you connect the unit to your TV via a fully-wired 21-pin SCART cable ( pg. 16), the following functions are available. You can use these functions only with a TV offering T-V Link, etc.*

For details, refer to the instruction manual of your TV.

*Compatible with TVs offering T-V Link, EasyLink, Megalogic, SMARTLINK, Q-Link or DATA LOGIC via a fully-wired 21-pin SCART cable. The degree of compatibility and available functions may differ by system.

TV Auto Power On

The TV will turn on and be set to its AV mode automatically whenever you start playback.

For details, refer to the instruction manual of your TV.

Unit Auto Standby

You can use your TV’s remote control to turn off the unit. For details, refer to the instruction manual of your TV.

Direct Rec

You can easily start recording the programme that you are watching on your TV. When you use this function, set “DIRECT REC” to “ON”. ( pg. 94)